216-459-8800 Gabriel@ghsohio.com
Cleveland Water Heater Odor Repair

Are you having an issue with foul odors originating from the water coming from your water heater? It occurs in certain cases for a couple different reasons. Here is what Water Heater Repair Cleveland Ohio suggests to do to make sure your water smells much better and to remove any undesirable taste quickly.

Causes for Cleveland Water Heater Odors?

Bacteria getting in the water system is the most typical explanation ones water inside the house could have odors. If you home makes use of well water or cities that use wells for the water source, raises the chance of this happening.

With a water heater temperature setting of 140 degrees or more will assist in minimizing the growth of microorganisms inside of the water storage tank.

How You Can Remove Foul Water Smells

The following directions explain the way to use chlorine bleach to clean a water heater.

The electric or gas leading to the water heater tank needs to first be turned off.

Next, the cold water supply off that leads to the tank needs to be turned off.

Open the hot water faucet of the kitchen area sink to allow air to enter the tank.

With a a yard hose hooked up to the storage tank drain valve, drain the water inside the water heater.

Then shut the drain valve as soon as it is empty.

The next step is putting in the bleach.
If the pipe for the cold water travelling into the storage tank is a flexible line, unscrew it from the tank. If not, one will have to take off the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be taken out.

Utilize a funnel to put bleach inside the tank.
Use 5 ounces of bleach for each gallon of the tank capacity.
So if you have a 50 gallon water heater, you will need 250 ounces of bleach, or about 2 gallons.

Hook the water line or pressure relief valve back up again

Fill the tank back up with water again.

Close the hot water faucet of the kitchen faucet as quickly as all the air is out of the line.

Operate all the hot water appliances up until the aroma of bleach is noticeable. We want to kill the germs that are in the water lines likewise, not just inside the water heater.

Let the water to stand in the tank and water lines without using and hot water for 2 to 3 hours.

Drain the storage tank once more and refill it. This time allow it to set for at least thirty minutes and just as before drain it.

Fill the tank back up. Open all of the hot water fixtures and let them run up until the scent of bleach is gone.

For gas water heaters, relight the water heater pilot light. For electric water heaters, turn the power on once more.

In addition, by replacing the anode rods, or simply the type utilized can work as the next video illustrates:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Cleveland Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog